Avbiter, Taper

Du kan velge mellom Semi-Flush, Flush eller Razor-Flush egg samt standard håndtak eller langt ergonomisk håndtak.

For en smalere variant velges "Oval relief":

Both cutting edges receive a very small bevel by diamond honing over the entire outer length. The bevels are at 90 degrees to the plane of the cutting surface. The bevels are no more than 0.25 to 0.35mm in width. When the cutter is closed the bevels form a V-shaped groove along the length of the cutting edge. This beveling results in a fine but very rugged interface between the two edges. In many applications a semi-flush Tronex cutter can produce hundreds of thousands of cuts before resharpening is necessary. However the lead or wire being cut will have a raised surface, or "pinch", exactly in the shape of the V-shaped groove.

FLUSH:

Both cutting edges receive a tiny bevel by diamond honing over the entire outer length. The bevels are at 60 degrees to the plane of the cutting surface. They are no more than 0.12mm in width and thus form an exceptionally small V-shaped groove along the edges. This beveling also results in a rugged and very long-lasting cutting edge interface. It also yields only the tinniest raised surface, or "pinch", on the cut lead. Many users of Tronex cutters believe that the Flush edge finish provides the most desirable balance between long cutting life, flush cut leads, and cost.

RAZOR-FLUSH:

There is no bevel on either cutting edge. The backside, or printed circuit board side, is absolutely flat at an angle of 45 degrees to the plane of the cutting surfaces. The exceptionally sharp edges produce cuts with virtually no raised surface on the lead. (Under a loupe you can see a line on the lead where the edges come together but you will not see a "pinch"). Also, minimum shock is imparted to the cut lead or component. However, more frequent sharpening is required with a Razor Flush® cutter. The Razor Flush® edge finish on Tronex cutters is executed by a proprietary process and thus unmatched by any other precision cutting tool in the world. It is also the edge finish selected for almost all specialty cutters (tip cutters and angulated cutters) made by Tronex.